CASCADE Documents
Safety Documentation
Preliminary Safety Cases
- Preliminary Safety Case for ADS-B Non-Radar Airspace (NRA), EUROCONTROL, 2008
- Preliminary Safety Case for ADS-B Radar Airspace (RAD), EUROCONTROL, 2011
- Preliminary Safety Case for ADS-B Visual Separation on Approach (VSA), EUROCONTROL, 2011
- Preliminary Safety Case for ADS-B Airports Surface Surveillance (APT), EUROCONTROL, 2011
- SRC Position Papers
Safety Assessment Methodology
You may access the SAM documentation here.
Safety Case Manual
You may access the Safety Case Manual here.
Supporting papers for ANSPs
To obtain operational approval from their national supervisory authorities ANSPs will have to demonstrate that their controllers are properly trained in the use of ADS-B. The following guidelines have been produced to assist in this task.
- Guidelines for Operational Approval
- ATC Manual for ADS-B NRA
- ATC Manual for ADS-B RAD
- Use of ADS-B for Enhanced Application of ATSA-VSA
- ATC Manual for ADS-B-APT V-1.0
- ATSA-AIRB ATC Info Leaflet V-1.0
- ATSA-SURF ATC Info Leaflet V-1.0
WAM
For further information on WAM you may consult the WAM section of the Surveillance Library.
Interoperability Requirements
The following documents can be obtained from EASA, EUROCAE , ICAO or RTCA websites as appropriate:
ADS-B application standards
- Safety Performance and Interoperability Requirements for ADS-B in Non Radar Airspace (ADS-B NRA), EUROCAE ED-126 / RTCA DO-303, 2006
- Safety Performance and Interoperability Requirements for ADS-B in Radar Airspace (ADS-B RAD), EUROCAE ED-161 / RTCA DO-318, 2009
- Safety Performance and Interoperability Requirements for ATSAW In-Trail procedure in oceanic airspace (ATSAW ITP), EUROCAE ED-159 / RTCA DO-312, 2008
- Safety Performance and Interoperability Requirements for ATSAW Visual Separation in Approach (ATSAW VSA), EUROCAE ED-160 / RTCA DO-314, 2008
- Safety Performance and Interoperability Requirements for ADS-B for Airport Surface Surveillance (ADS-B APT), EUROCAE ED-163 / DO-321, 2010
- Safety Performance and Interoperability Requirements for ATSAW during flight operations (ATSAW AIRB), EUROCAE ED-164 / DO-319, 2010
- Safety Performance and Interoperability Requirements for ATSAW on the Airport Surface (ATSAW SURF), EUROCAE ED-165 / RTCA DO-322, 2010
- Safety Performance and Interoperability Requirements for Flight Deck Interval Management (ASPA-FIM), EUROCAE ED-195, 2011
Airworthiness documentation, Technical Specification and MOPS:
- Acceptable Means of Compliance for ADS-B NRA (AMC 20-24), EASA, 2008
- Technical Specification for the ADS-B Ground Station, ED-129, EUROCAE, 2010
- Technical Specification for WAM system, , EUROCAE ED-142, October 2009
- Minimum Operational Performance Standards for 1090 MHz ADS-B and TIS-B, EUROCAE ED-102A / RTCA DO260B, 2009
- ICAO Doc 9871 ‘Technical Provisions for Mode S Services and Extended Squitter’ First Edition 2008
Legislation
The European Commission has recently promulgated an Implementing Rule, laying down requirements for the performance and the interoperability of surveillance for the Single European Sky. This Rule lays out the requirements for the carriage and operation of specified airborne surveillance equipment, and the dates by which qualifying aircraft must be equipped by. The rule in question is 'Commission Implementing Regulation (EU) No 1207/2011', published on 23/11/2011, and it can be downloaded here.