Active objectives

These colour codes are used to distinguish between the different implementation objectives:

This colour code is used to identify new or existing objectives with a new designator:

To see the detailed description of an objective, click on its designator in the left-hand column.

Every objective description starts with a cover page that lists the changes introduced (if any) since the beginning of the ESSIP Plan - Edition 2012 update cycle.

Outline Descrip.	Id.	Objective Title
-	AOM13.1	Harmonize Operational Air Traffic (OAT) and General Air Traffic (GAT) handling
	AOM19	Implement Advanced Airspace Management
	AOM20	Implement ATS Route Network (ARN) - Version 7
-	AOP01.2	Implement airside capacity enhancement method and best practices based on Eurocontrol capacity and efficiency implementation manual
-	AOP03	Improve runway safety by preventing runway incursions
-	AOP04.1	Implement Advanced Surface Movement Guidance and Control System (A-SMGCS) Level1
-	AOP04.2	Implement Advanced Surface Movement Guidance and Control System (A-SMGCS) Level 2
	AOP05	Implement Airport Collaborative Decision Making (CDM)
-	AOP08	Implement Airport Airside Capacity Planning Method
	AOP09	Implement Optimised Dependent Parallel Operations
-	ATC02.2	Implement ground based safety nets - Short Term Conflict Alert (STCA) - level 2
-	ATC02.5	Implement ground based safety nets - Area Proximity Warning - level 2
-	ATC02.6	Implement ground based safety nets - Minimum Safe Altitude Warning - level 2
-	ATC02.7	Implement ground based safety nets - Approach Path Monitor - level 2
-	ATC07.1	Implement arrival management tools
-	ATC12	Implement automated support for conflict detection and conformance monitoring
	ATC15	Implement, in En-Route operations, information exchange mechanisms, tools and procedures in support of Basic AMAN operations
	ATC16	Implement ACAS II compliant with TCAS II change 7.1
-	COM06	Migrate to ATS-Qsig digital signalling for ground telephone applications
	COM09	Migrate ground international or regional X.25 data networks or services to the Internet Protocol (IP)
	COM10	Migrate from AFTN to AMHS
	COM11	Implementation of Voice over Internet Protocol (VoIP) in ATM
-	ENV01	Implement Continuous Descent Approach (CDA) techniques for environmental improvements
	ENV02	Implement Collaborative Environmental Management (CEM) at Airports
-	FCM01	Implement enhanced tactical flow management services
-	FCM03	Implement collaborative flight planning
-	GEN01	Implement European ANS contingency measures for Safety Critical Modes of Operation
-	HUM01.1	Ensure timely availability of ATC
-	HUM02.1	Integrate Human Factors into ATM Operations
-	HUM03.1	Integrate Human Factors into the lifecycle of ATM systems
-	INF04	Implement integrated briefing
	ITY-ADQ	Ensure quality of aeronautical data and aeronautical information
-	ITY-AGDL	Initial ATC air-ground data link services above FL-285
-	ITY-AGVCS	Air-Ground voice channel spacing above FL-195
-	ITY-COTR	Implementation of ground-ground automated co-ordination processes
-	ITY-FMTP	Apply a common flight message transfer protocol (FMTP)
-	NAV03	Implementation of P-RNAV
	NAV10	Implement APV procedures
-	SAF04	Implement measures to reduce the risk of level bust occurrences
-	SAF05	Implement measures to prevent air/ground communications induced safety occurrences.
-	SAF10	Implement measures to reduce the risk to aircraft operations caused by airspace infringements
-	SRC-AUDI	Implementation of Safety Regulatory Auditing by National Supervisory Authorities (NSA)
-	SRC-CHNG	Implementation of Safety Oversight of Changes to ATM by National Supervisory Authorities (NSA)
-	SRC-OVCA	Implementation of ATM Safety Oversight Capabilities by NSAs
-	SRC-RLMK	Implement the EUROCONTROL Safety Regulatory Requirements (ESARRs)
-	SRC-SLRD	Safety Levels and Resolution of Deficiencies
-	SUR02	Implement Mode S elementary surveillance
-	SUR04	Implement Mode S enhanced surveillance
-	SUR05	Improve ground-based surveillance using ADS-B in Non Radar Airspace (NRA)